B&M shifter help

Bob Verwold · 12-12-2009, 07:30 PM

If your trans shifts ok by hand, I would guess the cable is in a bind (not enough of an easy bend) That's my .02

Dave Ribeiro · 12-12-2009, 09:21 PM

Ken,

Try what Bob said to do.... Make sure the tranny arm shifts easy by hand...If thats OK, check for a kink in the cable.. Try taking it off trans again and adjusting it in each gear to see if that helps ? Make sure you only remove at the eye-let , so the cable is still in the bent position... I think you may find it's in the tranny arm ? Good Luck & Merry Xmas....

rayfin · 12-19-2009, 09:28 PM

the cable is in a bind... been there done that

12-12-2009, 07:30 PM	#1
Bob Verwold Senior Member Join Date: Jul 2007 Location: Fayetteville Ohio Posts: 656 Likes: 0 Liked 0 Times in 0 Posts	Re: B&M shifter help If your trans shifts ok by hand, I would guess the cable is in a bind (not enough of an easy bend) That's my .02

12-12-2009, 09:21 PM	#2
Dave Ribeiro VIP Member Join Date: Sep 2002 Location: Williamsburg, Va.---USA Posts: 1,827 Likes: 1,612 Liked 56 Times in 27 Posts	Re: B&M shifter help Ken, Try what Bob said to do.... Make sure the tranny arm shifts easy by hand...If thats OK, check for a kink in the cable.. Try taking it off trans again and adjusting it in each gear to see if that helps ? Make sure you only remove at the eye-let , so the cable is still in the bent position... I think you may find it's in the tranny arm ? Good Luck & Merry Xmas.... __________________ Dave Ribeiro 1033 STK

12-19-2009, 09:28 PM	#3
rayfin Member Join Date: Mar 2009 Location: sioux city Posts: 134 Likes: 1 Liked 0 Times in 0 Posts	Re: B&M shifter help the cable is in a bind... been there done that

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode