|
|
|
|
05-30-2012, 10:18 PM
|
#1 |
|
Veteran Member
Join Date: May 2006
Location: Murfreesboro TN
Posts: 5,126
Likes: 1,583
Liked 1,883 Times in 423 Posts
|
Re: flex plate to converter spacers
Use thick AN type washers, or make your own with a lathe.
As mentioned elsewhere, make certain that the pilot of the converter extends well into the bore on the back of the crank shaft.
__________________
Alan Roehrich 212A G/S |
|
|
|
05-30-2012, 10:34 PM
|
#2 |
|
VIP Member
Join Date: Jun 2006
Posts: 3,423
Likes: 541
Liked 333 Times in 180 Posts
|
Re: flex plate to converter spacers
try TE-CO Union Ohio--they make xtra thick hardened washers usually for use in machine shops for machine tool holding but never the less they make them--- probably from 1/4 in dia up to 1 1/2 inch several thicknesses
|
|
|
|
|
06-01-2012, 10:41 AM
|
#3 |
|
VIP Member
Join Date: Nov 2008
Location: Glendora,Calif.
Posts: 1,137
Likes: 172
Liked 719 Times in 220 Posts
|
Re: flex plate to converter spacers
Ace Hardware has an assortment of thick washers. I bought some for just that purpose. Not having the converter in far enough can result in the front pump drive lugs breaking off. I learned that the hard way last year.
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
