Sears craftsman drill press

Donnie Moore Jr. · 07-03-2007, 09:35 PM

Quote:

Originally Posted by FED 387

Just got a Sears 13 inch benchtop drill press with a load of tools I bought at an estate sale... No chuck key anybody know where to find a model number on this thing ???? I'v looked all over cannot find anything except on the motor and nothing that Sears recognizes. It has the numbers of JT39 and 13MM stamped on the chuck but nothing else--- Thanx Dick

hey check with a matco tool dist. (if you have one close to you) #ck12050 has 4 different sizes for 3/8 chuck, #ck12060 1/2 I have sold a lot of those to people that have lost chuck keys just read your post again ck12060 should work for you because 13mm is is stamped on 1/2 chuck hope this helps

FED 387 · 07-03-2007, 09:45 PM

Thanx Donnie got a matco just down the road---Comp 387

FED 387 · 07-04-2007, 04:03 PM

Finnaly found the sears model number. Under the base plate was a sticker kinda scratched up but readable--- anyway went to the surplus store got a chuck works fine---- cost $2!!!!! Sears wanted $10.49 plus $6.95 shipping do not stock it.... Comp 387

07-03-2007, 09:45 PM	#2
FED 387 VIP Member Join Date: Jun 2006 Posts: 3,423 Likes: 538 Liked 333 Times in 180 Posts	Re: Sears craftsman drill press Thanx Donnie got a matco just down the road---Comp 387

07-04-2007, 04:03 PM	#3
FED 387 VIP Member Join Date: Jun 2006 Posts: 3,423 Likes: 538 Liked 333 Times in 180 Posts	Re: Sears craftsman drill press Finnaly found the sears model number. Under the base plate was a sticker kinda scratched up but readable--- anyway went to the surplus store got a chuck works fine---- cost $2!!!!! Sears wanted $10.49 plus $6.95 shipping do not stock it.... Comp 387

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode