Dan Fletcher Super Stock Videos - Opinions

[tpoh815]

Originally Posted by Mark Ugrich

One possibility would be a bad thrust bearing allowing the crank to move and bind against the converter.One of my cars had a "whine" only on coast.I found the flywheel bolts had printed the face of the converter.ARP bolts with thinner heads solved the problem.

This is caused by Dan treeing his opponent so bad he has time to whomp the gas so many times he literally makes ten passes for each run causing premature thrust bearing wear! Hence the "virbation".025 end play aint nothin !

[Mark Ugrich]

Originally Posted by tpoh815

This is caused by Dan treeing his opponent so bad he has time to whomp the gas so many times he literally makes ten passes for each run causing premature thrust bearing wear! Hence the "virbation".025 end play aint nothin !

Actually the situation I had was that the converter was tight against the flywheel bolts.It bound up the trans enough that I found shavings of thrust washer in the transmission pan.Not saying that's what's happening here,but I'm sure Mr. Fletcher will figure it out.

[Larry Hill]

If Dan can't fix it, he will spend enough time searching and finally worry it to death. He works very hard at his chosen craft!

[69Cobra]

Sounds like the ring and pinion to me.