|
|
|
|
11-11-2007, 02:04 AM
|
#1 |
|
Junior Member
Join Date: Feb 2007
Location: Wetumpka Alabama
Posts: 23
Likes: 0
Liked 0 Times in 0 Posts
|
Re: Inner tube nut
I think they are 3/8-24 . But don't hold me too that #
__________________
Mitch Perkins Perk-Bilt Race Cars DragCoverage.com Staff Photographer |
|
|
|
11-11-2007, 01:20 PM
|
#2 |
|
VIP Member
Join Date: Jun 2006
Posts: 3,428
Likes: 560
Liked 335 Times in 182 Posts
|
Re: Inner tube nut
I believe the correct nut thread size is either a 12 or 16 MM fine thread-Depends on the valve stem size---By the way these valves are known as PRESTA valves the other type is a SCHRADER which is the type most generally used in TUBELESS automotive applications------Right tho on the wheel spinning on the tire can cause mucho problems---Comp 387
|
|
|
|
|
11-11-2007, 02:27 PM
|
#3 |
|
Member
Join Date: Dec 2006
Location: Indy
Posts: 422
Likes: 0
Liked 1 Time in 1 Post
|
Re: Inner tube nut
Apply Palmolive dish soap to the sidewalls inside, and ditch the tubes.
|
|
|
|
|
11-11-2007, 09:25 PM
|
#4 |
|
Senior Member
Join Date: Oct 2006
Location: Parker, CO.
Posts: 728
Likes: 168
Liked 14 Times in 11 Posts
|
Re: Inner tube nut
Guys, thank you for the input. At this point the tubes will stay, later in 2008 I'll be switching
to MT radials and will leave the tubes out at that point.
__________________
Phil Saran Parker, Colorado |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
