|
|
12-13-2017, 04:28 PM
|
#10 |
|
Senior Member
Join Date: Dec 2001
Location: Elysburg, Pa
Posts: 733
Likes: 361
Liked 327 Times in 121 Posts
|
Re: Aftermarket/Replacement Cylinder Head Rule Change
I could be wrong but I don't think it is practical to use the Edelbrock head on the Max Wedge, the port mismatch would be quite a challenge since you cant enlarge the ports. If they raise the iron head HP to the aluminum head HP the factor would be higher than the original.
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode