Bellhousing

james schaechter · 01-14-2018, 10:05 AM

Quote:

Originally Posted by Dave Toce

This item is all set I'm on to other things now, I work quickly. I ended up using a Quciktime 1/4" thick steel midplate and adjusted the ball stud height to make up for the 1/4" extra depth.

Did all of the bolt holes line up Orr did you need to re drill some on the lower half?

Ed Carpenter · 01-14-2018, 03:38 PM

Browell and never look back!

Dave Toce · 01-15-2018, 08:27 AM

Quote:

Originally Posted by james schaechter

Did all of the bolt holes line up Or did you need to re drill some on the lower half?

The Quicktime part number 1/4" mid-plate I used is 6093, it is really only a spacer plate at the block upper half with mounting tabs and not a true full mid-plate. I cut the tabs off the side. Thus there are no holes on the lower area to align with the bellhousing. Obviously I still used the blocker saver plate that comes with the Mcleod bellhousing.

https://www.holley.com/products/driv.../parts/RM-6093

01-14-2018, 03:38 PM	#2
Ed Carpenter Live Reporter Join Date: May 2006 Location: Dripping Springs, Tx Posts: 2,709 Likes: 186 Liked 520 Times in 132 Posts	Re: Bellhousing Browell and never look back! __________________ Ed Carpenter 2005 Chevy Cobalt A/SM Race Engine Development

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode