cam degreeing help

bsa633 · 03-31-2009, 12:53 AM

Quote:

Originally Posted by Terry Waldron

Mark,Tried the one tooth off, did not help.Had degree bushing set at zero. Checked my degree wheel readings, first reading was 56 went to other reading it was164, total is220 divided is 110, same as all my readings. Never had a problem degreeing before.

If you get the same result by doing this you clearly built in a "mistake" in your doings..same as Bill K i had my moments when i just was too tired...

Terry Waldron · 04-01-2009, 09:21 PM

I want to thank all the racers for trying to help me, I got the problem straightened out.

Bob Pagano · 04-02-2009, 07:54 AM

Well clue us all in, we all have been following this thread ......what was the problem ?

Terry Waldron · 04-02-2009, 02:51 PM

The problem was when I did my first reading of the degree wheel it was right, but when I did my second reading I was reading it the opposite way so the numbers were always higher and almost always the same. I am right on now, tried different degrees just to make sure everything is working fine. Just a dumb mistake that I hate to admit to.

Bob Pagano · 04-03-2009, 09:00 AM

Dont feel bad we have all at one time or another done the same thing, there is alot going on at one time and its easy to get a bad reading. Its called the "school of hard knocks"

04-01-2009, 09:21 PM	#2
Terry Waldron Junior Member Join Date: Nov 2005 Location: silvis ill Posts: 40 Likes: 0 Liked 0 Times in 0 Posts	Re: cam degreeing help I want to thank all the racers for trying to help me, I got the problem straightened out. __________________ Terry Waldron 5619 K/S

04-02-2009, 07:54 AM	#3
Bob Pagano VIP Member Join Date: Jun 2002 Location: New Holland, PA Mooresville,NC Posts: 1,163 Likes: 243 Liked 16 Times in 11 Posts	Re: cam degreeing help Well clue us all in, we all have been following this thread ......what was the problem ? __________________ Bob Pagano A/SA

04-02-2009, 02:51 PM	#4
Terry Waldron Junior Member Join Date: Nov 2005 Location: silvis ill Posts: 40 Likes: 0 Liked 0 Times in 0 Posts	Re: cam degreeing help The problem was when I did my first reading of the degree wheel it was right, but when I did my second reading I was reading it the opposite way so the numbers were always higher and almost always the same. I am right on now, tried different degrees just to make sure everything is working fine. Just a dumb mistake that I hate to admit to. __________________ Terry Waldron 5619 K/S

04-03-2009, 09:00 AM	#5
Bob Pagano VIP Member Join Date: Jun 2002 Location: New Holland, PA Mooresville,NC Posts: 1,163 Likes: 243 Liked 16 Times in 11 Posts	Re: cam degreeing help Dont feel bad we have all at one time or another done the same thing, there is alot going on at one time and its easy to get a bad reading. Its called the "school of hard knocks" __________________ Bob Pagano A/SA