|
![]() |
#3 |
Member
Join Date: Nov 2005
Location: Waldorf Md
Posts: 230
Likes: 12
Liked 30 Times in 17 Posts
|
![]()
Chad,
I just threw 2 complete sets of .001" lower half Big Block Rod bearings away on Friday for the same reason. I figure if Clevite tells you to run them that way, there must be a reason. The engineering side of me says that the thicker bearing will conform to the diameter of the crankshaft better and will result in a larger bearing area as compared to the thinner one.
__________________
Bill Koustenis |
![]() |
![]() |
|
|