Epoxy/sealer for carb inlet fitting to bowl

Danny Ashley · 07-23-2010, 10:10 PM

Larry:
I tried to respond to your PM but it said you do not receive them and wouldn't sent it through. I use a product called MT-13 from Smooth-On.com. It was recommended to me by a gentleman that used to work for Rochester and now restores carburetors. He simply hates JB Weld. I repaired a friends Q-Jet the other day exactly the way you are wanting to do the Holley and I felt very good about the finished product. It's expensive but sounds like that carb is worth it. Good luck. Danny

07-23-2010, 10:10 PM	#4
Danny Ashley Member Join Date: Nov 2001 Location: Marion,In. Posts: 267 Likes: 60 Liked 110 Times in 29 Posts	Re: Epoxy/sealer for carb inlet fitting to bowl Larry: I tried to respond to your PM but it said you do not receive them and wouldn't sent it through. I use a product called MT-13 from Smooth-On.com. It was recommended to me by a gentleman that used to work for Rochester and now restores carburetors. He simply hates JB Weld. I repaired a friends Q-Jet the other day exactly the way you are wanting to do the Holley and I felt very good about the finished product. It's expensive but sounds like that carb is worth it. Good luck. Danny