|
|
04-09-2011, 09:35 AM
|
#8 |
|
VIP Member
Join Date: Dec 2001
Location: Texarkana Ark/TX
Posts: 2,446
Likes: 575
Liked 880 Times in 311 Posts
|
Re: Any machinists set valves on an DOHC motor?
Art,
What is the actual Rocker Ratio? You know,measured... Measure the lobe lift and then the valve lift @ "0" lash. Then divide the required lash, at the valve tip, by the RR and set at the roller. You do realize with a set up like that you can alter the RR with tip length of the valve. It can also move the cam timing around a little.
__________________
Adger Smith (Former SS) Last edited by Adger Smith; 04-09-2011 at 09:42 AM. |
|
|
|
|
Threaded Mode