Balancer is "friction welding"

joespanova · 08-22-2011, 05:36 PM

Alan , and all....thanks for the replies.

I called ATI ( Dave ) in tech and discussed this with him.

He was adamant that the balancer was way over due for an over haul for several reasons.

One of the reasons is that when new that balancer is only designed for an operating range below 8000 with the o'rings that come in it ( durometer ) . So it will be sent in and set up for what I am doing for as suggested by Alan a very reasonable cost.

I did not go into the 2 step with him other than to mention I now use one.......regardless he is very sure its all balancer related.

08-22-2011, 05:36 PM	#13
joespanova Senior Member Join Date: Jun 2011 Location: Ga. Posts: 521 Likes: 7 Liked 13 Times in 11 Posts	Re: Balancer is "friction welding" Alan , and all....thanks for the replies. I called ATI ( Dave ) in tech and discussed this with him. He was adamant that the balancer was way over due for an over haul for several reasons. One of the reasons is that when new that balancer is only designed for an operating range below 8000 with the o'rings that come in it ( durometer ) . So it will be sent in and set up for what I am doing for as suggested by Alan a very reasonable cost. I did not go into the 2 step with him other than to mention I now use one.......regardless he is very sure its all balancer related. Last edited by joespanova; 08-22-2011 at 05:43 PM.