OK, what the heck am I doing wrong?

Jim Kaekel · 11-10-2011, 02:52 PM

Bobby: You just need to get a set of offset cam degree bushings like those that Comp, Crane, etc. sell. Drill the cam gear so that it will accept a bushing and start from there. You may have to try a couple of different bushings to get to the manufacturer's recommended intake centerline. Follow the manufacturer's instructions regarding degreeing the cam. It's usually listed right on the cam card. A timing set such as the Cloyes Hex-a-Just makes this process very easy.

11-10-2011, 02:52 PM	#3
Jim Kaekel VIP Member Join Date: Jul 2002 Location: Michigan Posts: 1,229 Likes: 133 Liked 535 Times in 110 Posts	Re: OK, what the heck am I doing wrong? Bobby: You just need to get a set of offset cam degree bushings like those that Comp, Crane, etc. sell. Drill the cam gear so that it will accept a bushing and start from there. You may have to try a couple of different bushings to get to the manufacturer's recommended intake centerline. Follow the manufacturer's instructions regarding degreeing the cam. It's usually listed right on the cam card. A timing set such as the Cloyes Hex-a-Just makes this process very easy. __________________ Jim Kaekel 3836 STK