stocker cylinder heads

Mike Taylor 3601 · 12-14-2012, 10:18 AM

As I understand that is correct,can unshroud to head gasket bore,changing 30 to 45 or ? I think is allowed but have'nt checked,to verify that so I would check on valve angle. To decrease runner CC mill intake/ex surface.
I leave filler 1/8-3/16'' ish down in heat riser passage on bowl side,so it's filled but does'nt protrude into bowl area,and fill all the way to intake surface.
I have another 200 BOP if interested Ron.
Mike Taylor 3601

12-14-2012, 10:18 AM	#2
Mike Taylor 3601 VIP Member Join Date: Oct 2008 Location: Somerset,Ky Posts: 1,372 Likes: 354 Liked 307 Times in 103 Posts	Re: stocker cylinder heads As I understand that is correct,can unshroud to head gasket bore,changing 30 to 45 or ? I think is allowed but have'nt checked,to verify that so I would check on valve angle. To decrease runner CC mill intake/ex surface. I leave filler 1/8-3/16'' ish down in heat riser passage on bowl side,so it's filled but does'nt protrude into bowl area,and fill all the way to intake surface. I have another 200 BOP if interested Ron. Mike Taylor 3601