|
![]() |
#1 |
VIP Member
Join Date: Jun 2009
Location: Boulder City, Nevada 89005
Posts: 2,732
Likes: 2,796
Liked 2,472 Times in 696 Posts
|
![]()
I have had a Wilson Carb Adapter on back order for my kids SS small
block mopar -- Thermoquad to Victor Manifold for about Six months! Does anybody else make a good quality one or should I just leave in a home blended regular Generic Adapter and call it a Day? Is the Victor still the preferred set up on a Low Compression 340 and is there any point in porting the Manifold as it already flows more than the Heads by a Fair Amount. Appreciate any advice and opinions given either on this post or PM. |
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Dec 2008
Location: Richmond Hill GA (and Port Ludlow WA)
Posts: 4,295
Likes: 2,374
Liked 3,174 Times in 971 Posts
|
![]()
Don't claim to be an expert but regardless of what the heads flow I would think the less turbulence created prior to entry in the port would be a good thing. I have an adapter you're welcome to try...it's a casting from decades past, I can send you a pic if you want to look at it.
I'm curious about the Victor as well, hopefully someone will chime in...
__________________
Jim Carter 2340 Super Stock 2340 SST/2340 Stock Set another place at the table |
![]() |
![]() |
![]() |
|
|