|
|
![]() |
#1 |
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 390 Times in 170 Posts
|
![]()
The black bolt-in piece? PM me your shipping info and I'll send you one. Should have gotten one with the block.
__________________
Ed Wright 4156 SS/JA |
![]() |
![]() |
![]() |
#2 |
Member
Join Date: Mar 2007
Location: Des Allemands, LA
Posts: 365
Likes: 8
Liked 1 Time in 1 Post
|
![]()
Thanks Ed, it's not a bolt in piece. It's a shallow freeze plug type. Jegs has one listed for the Dart blocks that looks just like the one in my bowtie block. I'm not sure if they are the same diameter though.
__________________
4878 SS/GA 66CHEVY II |
![]() |
![]() |
![]() |
#3 | |
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 390 Times in 170 Posts
|
![]() Quote:
There aren't two small screw holes next to the cam bore?
__________________
Ed Wright 4156 SS/JA |
|
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Mar 2007
Location: Des Allemands, LA
Posts: 365
Likes: 8
Liked 1 Time in 1 Post
|
![]()
Ed, I'm not sure about the bolt holes. I should have the block back from the machine shop at the end of the week. I'll check and let you know. Thanks
__________________
4878 SS/GA 66CHEVY II |
![]() |
![]() |
![]() |
#5 | |
Member
Join Date: Nov 2005
Location: Waldorf Md
Posts: 230
Likes: 12
Liked 30 Times in 17 Posts
|
![]() Quote:
Why not just have the machine shop measure the hole and see if they have the correct plug, if it does not use the plate that is. I keep almost every size in stock and would probably give you one if I was doing the block.
__________________
Bill Koustenis |
|
![]() |
![]() |
![]() |
#6 |
Member
Join Date: Mar 2007
Location: Des Allemands, LA
Posts: 365
Likes: 8
Liked 1 Time in 1 Post
|
![]()
The block is already crated up and on its way back to me. I'm sure if I call them they would know which one is needed. I was placing an order from Jegs and wondered if it was something they may stock is the reason I asked the question here. Thanks for everyones help.
__________________
4878 SS/GA 66CHEVY II |
![]() |
![]() |
![]() |
#7 |
Veteran Member
Join Date: Mar 2005
Location: Sand Springs, OK
Posts: 8,132
Likes: 896
Liked 390 Times in 170 Posts
|
![]()
Daren, if it has stock size cam journals, and it turns out to have those two threaded holes, this factory piece is a nice heal. It's like a plug with an O ring, made on a flat plate with ears for the two screws. Slicker piece than a drive-in plug. I can't use it because I had 50mm roller cam bearings installed. The hole is too big now.
__________________
Ed Wright 4156 SS/JA |
![]() |
![]() |
![]() |
|
|