|
![]() |
#10 |
Member
Join Date: Nov 2005
Location: Waldorf Md
Posts: 230
Likes: 12
Liked 30 Times in 17 Posts
|
![]()
FSA,
After doing this stuff for close to 30 years, I found out a long time ago that the ONLY way to know is to get the actual retainer and locks that you "think" you need and try them. If they measure ok, then get the springs. Retainers and locks vary all over the place. Also, make sure that the locks you get are from the same manufacturer that the retainers are from. 10 degree locks from one manufacturer will not always fit 10 degree retainers from a different manufacturer. etc etc etc. I have gotten to where I HATE valve springs and retainers ![]() ![]()
__________________
Bill Koustenis |
![]() |
![]() |
|
|