Richmond Pro gear alert heads-up...

[Paul Merolla]

Originally Posted by Tod Lane

We made ours because we do so many in my shop. The RAYTECH tool is a big help too.

http://www.ratechmfg.com/toc.htm

Talk to Mary there.

Don't work for them, have used them and I am just passing along the info

Good info, Tod - I wish I had heard of them before I did my 12-bolt. What about their "Smart Sleeve?" They say duty cycle is better than a spacer and shims. http://www.ratechmfg.com/smart%20sleeve.htm
That would eliminate the idea of honing a bearing.
As a side note, I bought used gears when I was putting the car together. When I went to press the pinion bearing on, it just slid over by hand. Turns out the previous owner's setup guy takes a little off all his pinions to make setup easier. A few people predicted disaster at the time, but after 60 or so runs this year the oil came out clean and the pattern looks great.