headers glowing red

[Herbie Null]

piston at TDC - ON THE COMPRESSION STROKE, I know you have probally checked this. I had this happen to me 1 time, engine ran but headers got cherry hot. I was in a hurry and had the distributor on TDC #1 set on the wrong stroke.

[Jody Lang]

I don't think you can get away with that much timing with that low of a stall. Breaking motor in with that much timing wont be a problem. Driving on the street I think it would detonate.

With the primary rods in it (which is fine) with no load on engine the rods are down in the lean or big part of the rod. Just not enough fuel is getting past the rod/jet for the raised RPM.

As a quick fix when breaking cams in I've just ran some duck tape across the choke area to richen it up. Cherry red exhaust will be gone. Don't forget to remove duck tape after break in.

[henrys57wagon]

Thanks again guys.
We finally got back to the Nova. I took the carb apart at home and cleaned/ blew it all out. We put the carb on and set the timing to 36# at 3000. The headers glowed so we put the old HEI back in ran it up and set the timing to 36 and the header glowed!!!!

We took the carb off and went to put the spare on but were missing a plug for this carb so I said lets put the 1st carb back on and see what happens.
Well low and behold everything worked fine??????????

So with the throttle plates drilled with a 1/8" hole the plate is above the idle slots and idling at 1100 in neutral, dropping to about 800 in gear.

What if we drill another 1/16 hole in each plate or would you recommend opening up the 1/8 hole to 3/16? Thanks, Henry.

[Alan Roehrich]

I'm not sure you should need a 3/16" hole in the throttle blades to get it to idle.