Pinion angle

Signman · 07-25-2014, 05:19 PM

Quote:

Originally Posted by Stewart Way

Frank
On a Mopar the engine is also offset to the right as is the pinion. Is the pinion in the Camaro offset also? How far off center is the engine/pinion? Just curious.

It's years since I did that measurement when building my stocker but 5/8" to the right is a recollection. Depending on what rear housing you put in it pinion location may not be where it needs to be relative to the trans. yoke. It's worth checking if your looking for maximum or near as possible efficiency.

Mark Yacavone · 07-25-2014, 06:45 PM

Pinion is offset 1'' in a factory 12 bolt. This is how you are able to use the same length axles both sides

07-25-2014, 06:45 PM	#2
Mark Yacavone Veteran Member Join Date: Mar 2002 Location: Miles From Nowhere Posts: 7,821 Likes: 2,912 Liked 5,133 Times in 1,957 Posts	Re: Pinion angle Pinion is offset 1'' in a factory 12 bolt. This is how you are able to use the same length axles both sides __________________ "We are lucky we don't get as much Government as we pay for." Will Rogers