# of axle splines in an E-body stocker

GallopinGhost · 10-17-2014, 01:55 PM

Thanks for the replies.

Well gents, getting the prices together really made this a no brainer. To "fix" my 8.75 will cost $1300 not counting my labor. I'd have to buy a spool/axle package, back brace, bearings, yoke, R&P, wheel studs, carrier caps w/needed machining according to mark williams website.

For a new rear end, components are: pro gear, 5/8 studs, spring pads welded, cast yoke, spool, axles. may go with a forged yoke though.

Strange: $2000, free shipping until end of yr.
Moser: $2400, + 225 shipping.

So for another $700 I get an assemble dana delivered. Just need to pick a gear ratio before I can order. Either 4.88 or 5.13. Motor package isn't figured out yet, but I think the 4.88 would be a safe start. Suggestions ????

10-17-2014, 01:55 PM	#14
GallopinGhost Member Join Date: Jun 2010 Location: VA Posts: 230 Likes: 23 Liked 21 Times in 13 Posts	Re: # of axle splines in an E-body stocker Thanks for the replies. Well gents, getting the prices together really made this a no brainer. To "fix" my 8.75 will cost $1300 not counting my labor. I'd have to buy a spool/axle package, back brace, bearings, yoke, R&P, wheel studs, carrier caps w/needed machining according to mark williams website. For a new rear end, components are: pro gear, 5/8 studs, spring pads welded, cast yoke, spool, axles. may go with a forged yoke though. Strange: $2000, free shipping until end of yr. Moser: $2400, + 225 shipping. So for another $700 I get an assemble dana delivered. Just need to pick a gear ratio before I can order. Either 4.88 or 5.13. Motor package isn't figured out yet, but I think the 4.88 would be a safe start. Suggestions ???? __________________ Brian Carpenter Stock 1358 Last edited by GallopinGhost; 10-17-2014 at 01:57 PM.