rotisserie

Stewart Way · 11-28-2007, 09:49 PM

Don't know where your located but I just bought one from Greg Smith Equip in Atl. They are also in Del and Indy. Around $900 with the jack arrangement for centering the load. I have a 68 Cuda on it now. Not quite as close tolerance as a AutoTwirler but seems to work well and $400 cheaper. You will have to custom fab front and rear mounts but the post above gave a site with dimensions for them.
Good luck and be careful.
It just ain't natural looking at your car on its side in your shop.

Harry 6674 · 12-07-2007, 06:54 PM

This is the one I built. Works good. My stocker 68 Camaro has been on it about 6 months. I put some beefy casres on it so it rolls easy with a car on it. I also used a long piece of tubing to connect the ends after the car is attached. www.autobody101.com/rotisserie.php

11-28-2007, 09:49 PM	#1
Stewart Way Member Join Date: Aug 2003 Location: Atlanta Posts: 476 Likes: 20 Liked 70 Times in 22 Posts	Re: rotisserie Don't know where your located but I just bought one from Greg Smith Equip in Atl. They are also in Del and Indy. Around $900 with the jack arrangement for centering the load. I have a 68 Cuda on it now. Not quite as close tolerance as a AutoTwirler but seems to work well and $400 cheaper. You will have to custom fab front and rear mounts but the post above gave a site with dimensions for them. Good luck and be careful. It just ain't natural looking at your car on its side in your shop.

12-07-2007, 06:54 PM	#2
Harry 6674 Senior Member Join Date: Dec 2006 Posts: 589 Likes: 0 Liked 0 Times in 0 Posts	Re: rotisserie This is the one I built. Works good. My stocker 68 Camaro has been on it about 6 months. I put some beefy casres on it so it rolls easy with a car on it. I also used a long piece of tubing to connect the ends after the car is attached. www.autobody101.com/rotisserie.php