Mounting Kirkey Seats to a Cross Bar

[Jim Kaekel]

FireSale: There are neat looking clamps from Allstar Performance that attach direct to the roll bar that come tapped with 1/4" threads. I attached two clamps to the cross bar and then used 1/4" bolts from the Kirkey upper mount to each clamp. Allstar part no. 10459 attaches directly to 1-3/4" tubing. There are other sizes available as well. Works and looks great.

[FireSale]

Originally Posted by Jim Kaekel

FireSale: There are neat looking clamps from Allstar Performance that attach direct to the roll bar that come tapped with 1/4" threads. I attached two clamps to the cross bar and then used 1/4" bolts from the Kirkey upper mount to each clamp. Allstar part no. 10459 attaches directly to 1-3/4" tubing. There are other sizes available as well. Works and looks great.

Thanks. I have a set of those that attach my relay panel to the cage support bar behind the passenger seat. It's 1 5/8 tubing so I had to make "rod bearings" out of scrap aluminum to make it fit OK. I can do that again if I can't find Allstar parts for 1 5/8 tubing.

That will fit the bill just fine.

Dale

[Jim Kaekel]

The Allstar part no. for 1-5/8" is 10460.

[FireSale]

Jim: Order confirmation received at 12:22 today from Jegs. The ballast brackets were cheaper but these have a lower profile.

Thanks for the help. They were right in the car holding my electrical panel, but I never thought of them.

Dale