WTB 454 Block

Gary Merrick · 05-30-2017, 10:27 PM

Jeff,

I have a 1970 454 block that was used in a stock car, which is .060" over stock bore and has been poured. It needs a sleeve and I would probably have it aligned honed for piece of mind. I also have a 1968 427 block that is also .060" over and it has not been used since being bored, it is also poured. Both of these blocks have been converted to 4 bolt mains.

Gary Merrick
330-219-4738

PS Must be an Ohio thing, these are located near Youngstown, Ohio.

05-30-2017, 10:27 PM	#1
Gary Merrick Member Join Date: Sep 2007 Posts: 210 Likes: 450 Liked 196 Times in 29 Posts	Re: WTB 454 Block Jeff, I have a 1970 454 block that was used in a stock car, which is .060" over stock bore and has been poured. It needs a sleeve and I would probably have it aligned honed for piece of mind. I also have a 1968 427 block that is also .060" over and it has not been used since being bored, it is also poured. Both of these blocks have been converted to 4 bolt mains. Gary Merrick 330-219-4738 PS Must be an Ohio thing, these are located near Youngstown, Ohio.