|
|
06-12-2017, 07:13 PM
|
#1 |
|
Member
Join Date: Nov 2001
Location: Marion,Ohio
Posts: 247
Likes: 48
Liked 50 Times in 28 Posts
|
Third gen camaro z/28 question
Need to know what kind of hardware is used to attach front bumper ground effects to the bumper on a '85 Z/28.
|
|
|
|
06-13-2017, 12:27 AM
|
#2 | |
|
Member
Join Date: Jun 2004
Location: Kennedale,Tx
Posts: 227
Likes: 0
Liked 2 Times in 2 Posts
|
Re: Third gen camaro z/28 question
Quote:
|
|
|
|
|
|
06-14-2017, 09:31 PM
|
#3 |
|
Member
Join Date: May 2014
Location: E TN
Posts: 473
Likes: 16
Liked 133 Times in 76 Posts
|
Re: Third gen camaro z/28 question
Car's loaded in the trailer, if I get a chance I'll try and look tomorrow. If I remember correctly there were metal plates that had threads in them that went behind the bumper and the ground effects bolted to them.
Just went and looked and I remembered correctly. There are square metal plates that go on the bumper side. The bolts go from the bottom and have large washers on them. Last edited by Eman; 06-15-2017 at 01:57 PM. |
|
|
|
|
06-16-2017, 01:26 PM
|
#4 |
|
Member
Join Date: Nov 2001
Location: Marion,Ohio
Posts: 247
Likes: 48
Liked 50 Times in 28 Posts
|
Re: Third gen camaro z/28 question
Thanks
|
|
|
|
|
06-17-2017, 12:34 AM
|
#5 |
|
Member
Join Date: Jun 2004
Location: Kennedale,Tx
Posts: 227
Likes: 0
Liked 2 Times in 2 Posts
|
Re: Third gen camaro z/28 question
That is a real website by the way. I have a 96 Z28 and I go on there a lot. It's not like this place..but there's a few really good people on there....good luck!
|
|
|
|
 |
|
|
Linear Mode
