428 ford camshaft

[carl hinkson]

Originally Posted by Glenn Briglio

I'm doing a 428 engine for a customer.Stock rebuild for a 1968 Shelby gt500. Looking for oem lift, duration at .050on intake and exhaust and intake and exhaust centerlines for camshaft.

Check with Keith Craft http://www.keithcraft.com/ He can come up with those number for you.

The last one I did the lifter bores were worn out had to bush them back and when it was all said and done I went with a HYD roller this was about 5 years ago and car goes really good. It was in a Drag Pack Mustang.