Solid lifters in Stock

Nmbr1GMfan · 02-05-2019, 06:55 PM

I am in the process of switching from hydraulics to solids on the same cam (originally ground by crane who was of little help to me) (maybe I talked to the wrong guy). Called Bullet, they were very very helpful and instructed me to swap to an "EDM" lifter @ .008 hot. I'm going to tighten the lash from there on the dyno to see if there's any + or - results. I hope there is a peformance improvement for me with lifters, pushrods, rockers and properly setup springs.

02-05-2019, 06:55 PM	#9
Nmbr1GMfan VIP Member Join Date: Aug 2013 Posts: 1,763 Likes: 1,197 Liked 1,954 Times in 491 Posts	Re: Solid lifters in Stock I am in the process of switching from hydraulics to solids on the same cam (originally ground by crane who was of little help to me) (maybe I talked to the wrong guy). Called Bullet, they were very very helpful and instructed me to swap to an "EDM" lifter @ .008 hot. I'm going to tighten the lash from there on the dyno to see if there's any + or - results. I hope there is a peformance improvement for me with lifters, pushrods, rockers and properly setup springs. __________________ Todd Greene