|
|
![]() |
#1 |
Veteran Member
Join Date: Mar 2002
Location: Miles From Nowhere
Posts: 7,821
Likes: 2,915
Liked 5,133 Times in 1,957 Posts
|
![]()
When you get close to 1.00 under runs, you've got to hold back some. Don't want to hit that trigger more than once per half season.
__________________
"We are lucky we don't get as much Government as we pay for." Will Rogers |
![]() |
![]() |
Liked |
![]() |
#2 |
VIP Member
Join Date: Nov 2001
Location: Florida
Posts: 1,542
Likes: 34
Liked 138 Times in 51 Posts
|
![]()
* Normally shift at a lower RPM, then shift at the optimum RPM during heads-up race.
* Swap out your normal oil for a lower viscosity. i.e.: normal 10w-30 conventional oil, heads-up 5w-20 or less special conventional or synthetic.(Consult your engine builder.) * Rear end can usually have a quart or a bit more drained below normal capacity. * Advance/optimize timing if running conservative. * Make sure your jetting is optimized without a filter if removing it. Otherwise, removing the filter may lean out the carb if the filter has any restriction * Add air to rear tires, IF it will hook with a smaller contact patch. * If cutting weight close to minimum, remember to weigh EXACTLY what you take out and include the weight of any oil drained. Keep a little safety margin. * Adding air to front tires will help minimize rolling resistance too, but it can also reduce rollout and quicken RTs. (Don't redlight.) * Switching from same size bias ply slicks to radial slicks usually helps pick up ET as well as RT. But finish line RPMs will be a bit higher because radials don't grow like bias ply. (As long as your engine can handle it.) Just remember that you have to be able to return to a predictable dial-in afterwards for the next run if you win the heads-up race.
__________________
LOCOMOTION Racing Last edited by Myron Piatek; 04-10-2019 at 05:16 PM. |
![]() |
![]() |
Liked |
![]() |
#3 |
VIP Member
Join Date: Dec 2001
Location: phoenix
Posts: 1,489
Likes: 66
Liked 706 Times in 283 Posts
|
![]()
* Make sure your jetting is optimized without a filter if removing it. Otherwise, removing the filter may lean out the carb if the filter has any restriction
^^^ This. We had a street car event and in the final round we needed a little bit more as it was heads up. I said take the air filter off and then proceed to run .1 slower in ET. and lost the race. Then realized car went lean with filter off. Ooops |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Oct 2009
Location: columbus, georgia
Posts: 385
Likes: 66
Liked 309 Times in 88 Posts
|
![]()
Some of you may remember Don Carter from South Carolina who ran C/SA in the nineties with a red 69 Nova, one way to remember him is he looked like one of the Oak Ridge boys. Anyway Don had a headsup first round at the GV divisional in that period with some one who had him covered a bunch. I asked him in staging if he had a plan and he stated he was going to pray, the faster car broke in the water.
|
![]() |
![]() |
Liked |
![]() |
#5 |
Junior Member
Join Date: Dec 2015
Location: waconia mn
Posts: 92
Likes: 21
Liked 9 Times in 5 Posts
|
![]()
How does engine temp play a factor? I see everyone putting ice on the intake and fuel regulator, pushing their cars through staging. What is an optimal engine temp?
|
![]() |
![]() |
![]() |
#6 | |
VIP Member
Join Date: Feb 2014
Location: Derby City, USA
Posts: 3,653
Likes: 1,088
Liked 8,105 Times in 1,531 Posts
|
![]() Quote:
|
|
![]() |
![]() |
Liked |
![]() |
|
|