Ford Performance P/N M-9603-CJN (Air Intake/Box)

[Jesse Kershaw]

Originally Posted by 201250

I seem to recall a similar set-up when the 429 NINGA motor was used in Factory Stock? Picture I saw was one I assume Chris Holbrook had made. Nice design, very custom.

we did have a similar unit on the 429 engine. It was made by Watson but was a 2-piece design so it could be installed with the factory fascia and radiator in place. THe bottom slipped in from the top and then the lid bolted on. I did some basic design work with a Mustang aero engineer that had done wind tunnel testing but not much more than that went into it's development.

I'm not familiar with this new one but I think it's on the 2019 CJ and that has an aftermarket radiator on it (at least the one I saw did). THis inlet could require a different radiator, I'd at least ask before buying.

[SSDiv6]

I have seen two versions of the 429 Ninja air intake, one was aluminum and the other was either fiberglass or carbon fiber. Both of them had the Ford Racing part number ID plate on them.