ONAN Marquis Gold 7000 Gas

voltdr · 08-04-2019, 11:25 PM

There were some blind holes in the upper plate that I tapped for 3/8” eyebolts. I then made some straps to separate the 2 halves. When I removed the coils to remove the flywheel, I put the coils back but the air gap was at the maximum distance allowed by the adjustment in the bolts holes. After I reset the gap to .012” and reassembled the generator, it started and ran fine. Thanks again for the tips.
Dan

08-04-2019, 11:25 PM	#19
voltdr Senior Member Join Date: Jan 2008 Location: Texas Posts: 706 Likes: 77 Liked 100 Times in 51 Posts	Re: ONAN Marquis Gold 7000 Gas There were some blind holes in the upper plate that I tapped for 3/8” eyebolts. I then made some straps to separate the 2 halves. When I removed the coils to remove the flywheel, I put the coils back but the air gap was at the maximum distance allowed by the adjustment in the bolts holes. After I reset the gap to .012” and reassembled the generator, it started and ran fine. Thanks again for the tips. Dan __________________ Dan Foley SC 4698