Shutting off engine crossing finish line

Jared Jordan · 09-03-2019, 08:26 PM

Not as hard on parts, in general, but it does depend on the car.

The '65 SS/BA Belvedere I drove once upon a time would tear up rod bearings if I didn't go into neutral past the finish line. Never tied itself up because Grandpa was meticulous about maintenance; particularly the preventative type. After we went to "clean neutral" in the valve body and I could kill it at the stripe, that was never an issue again.

On the other hand, my '64 Dodge H/SA car has great oil pressure through the entirety of the shutdown area and does not have a "clean neutral." Racepak shows a line that descends in correlation to engine RPM, but no dips whatsoever.

09-03-2019, 08:26 PM	#6
Jared Jordan Senior Member Join Date: Jun 2004 Location: Modesto, CA Posts: 614 Likes: 200 Liked 540 Times in 120 Posts	Re: Shutting off engine crossing finish line Not as hard on parts, in general, but it does depend on the car. The '65 SS/BA Belvedere I drove once upon a time would tear up rod bearings if I didn't go into neutral past the finish line. Never tied itself up because Grandpa was meticulous about maintenance; particularly the preventative type. After we went to "clean neutral" in the valve body and I could kill it at the stripe, that was never an issue again. On the other hand, my '64 Dodge H/SA car has great oil pressure through the entirety of the shutdown area and does not have a "clean neutral." Racepak shows a line that descends in correlation to engine RPM, but no dips whatsoever. __________________ Jared Jordan 9 B/SA 2024 Jeg's D7 All Star - Stock