|
|
|
|
09-16-2020, 07:22 AM
|
#1 |
|
Live Reporter
Join Date: Oct 2004
Location: Hickory, Ky
Posts: 10,682
Likes: 1,993
Liked 11,012 Times in 2,263 Posts
|
Re: carb
Is the mounting surface level on intake side to side?
|
|
|
|
09-16-2020, 08:06 AM
|
#2 |
|
Member
Join Date: Oct 2017
Location: Bay City Texas
Posts: 393
Likes: 2
Liked 227 Times in 138 Posts
|
Re: carb
Change both gaskets float bowl side and main body side also replace the the 4 bowl screw gaskets and torque the the bowl screws to 35 in-pounds and your problem should go away.
|
|
|
|
|
09-16-2020, 11:00 AM
|
#3 |
|
Member
Join Date: Mar 2006
Location: EL PASO, TEXAS
Posts: 156
Likes: 0
Liked 2 Times in 2 Posts
|
Re: carb
power valve hitting the base plate screw "boss" in the vac. chamber not allowing the m/block gasket to seal to the venturi surface. this is a common problem with "older" venturi's. check a new venturi an you'll see what i mean..
this is also made worse if you are using the new non-compressible p/valve gasket with a mill'd surface of the venturi as they become closer together. |
|
|
|
| Liked |
|
09-16-2020, 11:27 AM
|
#4 |
|
Senior Member
Join Date: Jun 2003
Location: Las Vegas nv
Posts: 600
Likes: 18
Liked 66 Times in 37 Posts
|
Re: carb
o ring on needle and seat
__________________
72 cutlass |
|
|
|
 |
|
|
Hybrid Mode
