Selecting Rear End Gear ratio

Mike Pearson · 01-03-2021, 10:57 AM

There is not much ET made in the second half. The short times are what you need to work on.

Mike Rietow · 01-08-2021, 01:41 PM

This is a 845 SLR 1.69 low gear 3200lb n/a 23 sbc on a 10x28 bias 2400 d/a SGMP.

I'd like to see what she could do on radials in some good conditions, although I don't believe she'd pickup as much as some of have on radials. Might go low 1.20 though.

This is a engine & transmission I assembled, all steel Nova front & back seat delete. Transmission Specialties spragless converter B-crcxls. Ran like this off the trailer new.

3.875 x 4.185 Brodix T1 233 out the box, Bullet rollerstick.

01-03-2021, 10:57 AM	#1
Mike Pearson VIP Member Join Date: Mar 2007 Posts: 2,456 Likes: 618 Liked 1,945 Times in 586 Posts	Re: Selecting Rear End Gear ratio There is not much ET made in the second half. The short times are what you need to work on. __________________ Mike Pearson 2485 SS

01-08-2021, 01:41 PM	#2
Mike Rietow Junior Member Join Date: Apr 2017 Posts: 93 Likes: 19 Liked 30 Times in 16 Posts	Re: Selecting Rear End Gear ratio This is a 845 SLR 1.69 low gear 3200lb n/a 23 sbc on a 10x28 bias 2400 d/a SGMP. I'd like to see what she could do on radials in some good conditions, although I don't believe she'd pickup as much as some of have on radials. Might go low 1.20 though. This is a engine & transmission I assembled, all steel Nova front & back seat delete. Transmission Specialties spragless converter B-crcxls. Ran like this off the trailer new. 3.875 x 4.185 Brodix T1 233 out the box, Bullet rollerstick. __________________ 7x S/Pro 'Sunshine" http://ottm.store https://youtu.be/I8QWEaqeFRw Last edited by Mike Rietow; 01-09-2021 at 03:20 AM.