2 step activation.

[littlemanjoe]

Originally Posted by Doug Hoven

I think it all depends on the brake system of the car. The nova has completely stock factory 4 wheel manual drums. I set the brake pressure switch to activate at 700lbs. I should NEVER see that kind of pressure hitting the brakes at the end of the track unless there is a panic situation, and even then that would be well into the lock up range. I've heard of racers running them lower and higher than that. The switch I use also allows for an adjustable setting for where you would want the 2 step to deactivate. Allows for some more fine tuning in your reaction time. I'd say set it up where you feel comfortable the car is going to hold as well as where you can naturally hold that pressure without having to worry about if your foot is down hard enough.

Hey Doug, Thank you for the helpful info.
Where would a good spot be to set the reset point?

[Doug Hoven]

Originally Posted by littlemanjoe

Hey Doug, Thank you for the helpful info.
Where would a good spot be to set the reset point?

The switch that I use suggests at least 50psi split between the activate and reset pressures. Right now I have them about 100psi apart. This is where the little bit of reaction adjustability can come into play.

[garyc]

just remembered this from my dads 1962 buick when I was in high school (1973)
napa switch SL139 wire connector ARC120 $8.00 each