|
|
|
|
05-06-2022, 11:54 AM
|
#1 |
|
Senior Member
Join Date: Aug 2004
Location: Jacksonville, Florida
Posts: 808
Likes: 7
Liked 20 Times in 12 Posts
|
Re: 2 step low rpm
I have a adjustable MSD chip in a footbrake car a OHM meter is nec to check it but you can make a quick change in the car and see. Slightly diff question would anyone speak to me about what changes are needed to be done to a Qjet to use a 2 step on my footbrake car. Thank You
|
|
|
|
05-06-2022, 12:47 PM
|
#2 |
|
Member
Join Date: Nov 2001
Location: Marion,In.
Posts: 267
Likes: 60
Liked 110 Times in 29 Posts
|
Re: 2 step low rpm
Robert: In some cases, it may be necessary to tighten the air valve tension slightly when going from foot braking to 2-stepping. It depends on the tension you have as a starting point. It could be that it's tight enough and you won't have to do anything. I would try it as is and if you notice any "fluttering", then tighten it a little. Hope this helps.
|
|
|
|
| Liked |
|
05-08-2022, 10:06 PM
|
#3 |
|
VIP Member
Join Date: Apr 2002
Location: Coarsegold, CA
Posts: 1,016
Likes: 57
Liked 320 Times in 102 Posts
|
Re: 2 step low rpm
Just buy an 8735 MSD Launch Control….
It takes 2 chips 1 for burn out and 1 for high RPM, but the Launch Control has dials to set the leave RPM Easy, Peasy
__________________
Bob Mulry 7516 STK A & M Motorsports |
|
|
|
| Liked |
 |
|
|
Hybrid Mode
