OK, Stocker "valve jobs".

[goinbroke2]

Originally Posted by Billy Nees

I hope that you're cutting up a set of junk heads because by the time that you get done doing what you're doing, you can probably throw them away!

All I'm cutting is valve seats which can be replaced and the valves which can be replaced. I get your point though...this is getting rediculous.

So, all I can find is milodon +.050 valves but they are 1.60 so I'd have to cut them to 1.46 so that's no good. Can't find longer stock diameter valves.

Another option is replace the springs which is what I think I'll do. I think I'll stop by Armstrongs again and hopefully they have something in stock.

I mixed and matched the 3 springs and 5 retainers I already have here and so close but not good enough.