Brake Pressure Switch for launch control ???

[Rich Biebel]

Originally Posted by Mike Merk

I haven't done it with a reverse pattern but I think it could be done fairly easily by mounting a momentary, lever micro switch on a bracket attached at the trans pan rail or in tandem with the shift cable bracket. Switches like these are available in short or long arm for less than $20. Should be able to activate when the shift lever arm is in low gear only.

The problem with that on a reverse pattern is the shifter or lever is moving toward the switch as you upshift. The switch would also be in the way going back to N-R-P

I've made switches like that on other cars but the shift pattern was forward.

I'm sure it can be done but it takes some thought and fabrication

The built in neutral start switch posted above is a good solution