Pro's and Con's of a crank scraper.....

[Tom Goldman]

Originally Posted by tpoh815

Im betting I have 2-3 hours time in fabricating my crank scraper.Im sure it does something. lol

I've been using scrapers from a company in Fla. called Ishara- Johnson....The rough fit is pretty good on most motor..........Bub, I agree you cant make them too close and I found it didn't like the baffel windage tray I was using. ........ ....I think the results can really be measured by the on track oil pressure control, not just horsepower gains.........I've hurt a few parts over the years experimenting with my setup but ,i'm finally satisfied with the benefits.... ......With a SBC it may not even be necessary since the "accepted" stock appearing pans from Milodon and Canton seem to work pretty well.....................Bottom line? your results may vary. .....Tom