3rd Generation Camaro, Chassis by Ed Quay , Brand New

holley · 09-14-2013, 02:47 PM

Built by Ed Quay for Super Stock. Great project as all the chassis / fab work including tin has been completed by Ed Quay, Car has the following components: Kirky seats,Mallory fuel pump and filter, ARC switch panel, 4 link suspension, Front Springs, Wheelie Bars, 9" Ford rear, Monocoque rear rims, Mark Williams axles, VDO playback tach, Jaz Fuel cell, battery mounts, Diest window net, Quay Master cylinder, Full cage, Quay headers Jet hot coating, Front, mid engine plate for small block, engine limiters, trans cross member, drive-shaft loop, wishbone track limiter, most components yellow plated or black zinc. This car wasn't completed due to illness, All parts mentioned brand new, never used. Ed ALWAYS uses the best parts.
This was in process of becoming a rotisserie car to detail body, interior etc. 2 NOS GM doors, 2 NOS GM fenders and much more NOS parts. Over $26,000.00 invested, Over 21,000.00 when it left Ed Quay shop in 2002 just for fab work and parts. Car needs some assembly and an enthused pair of hands. Would also make a great bracket car.

Priced for quick sale. Great opportunity to get into a great chassis for way less than half the cost.
Serious inquires please, if this car doesn't sell quick it will be parted out as many racing component parts and NOS parts are still in demand.

09-14-2013, 02:47 PM	#1
holley Junior Member Join Date: Jan 2013 Posts: 28 Likes: 0 Liked 0 Times in 0 Posts	3rd Generation Camaro, Chassis by Ed Quay , Brand New Built by Ed Quay for Super Stock. Great project as all the chassis / fab work including tin has been completed by Ed Quay, Car has the following components: Kirky seats,Mallory fuel pump and filter, ARC switch panel, 4 link suspension, Front Springs, Wheelie Bars, 9" Ford rear, Monocoque rear rims, Mark Williams axles, VDO playback tach, Jaz Fuel cell, battery mounts, Diest window net, Quay Master cylinder, Full cage, Quay headers Jet hot coating, Front, mid engine plate for small block, engine limiters, trans cross member, drive-shaft loop, wishbone track limiter, most components yellow plated or black zinc. This car wasn't completed due to illness, All parts mentioned brand new, never used. Ed ALWAYS uses the best parts. This was in process of becoming a rotisserie car to detail body, interior etc. 2 NOS GM doors, 2 NOS GM fenders and much more NOS parts. Over $26,000.00 invested, Over 21,000.00 when it left Ed Quay shop in 2002 just for fab work and parts. Car needs some assembly and an enthused pair of hands. Would also make a great bracket car. Priced for quick sale. Great opportunity to get into a great chassis for way less than half the cost. Serious inquires please, if this car doesn't sell quick it will be parted out as many racing component parts and NOS parts are still in demand.