|
![]() |
#1 |
Junior Member
Join Date: May 2007
Location: springfield OR
Posts: 70
Likes: 1
Liked 39 Times in 5 Posts
|
![]()
Looking for some ideas on the cause. Car is leaving very lazy and has a hesitation at the hit of the throttle. It cleans up and runs strong after about 4,500 in first gear. Tried a spare carb, but unsure if it was good or not, and had the same results. Swapped converters to a known good one and replaced the ignition coil. The fuel pressure is staying steady at 7 1/4. The car is a 72 454 Corvette running in C/SA. The motor is fresh/new and was dynoed. Neither my carb or igntion were part of the dyno testing. Both sat for about a year without usage. Let me know if you have any ideas on what to look for/test. Thanks
Norm Webber
__________________
Norm Webber |
![]() |
![]() |
![]() |
#2 |
VIP Member
Join Date: Mar 2002
Posts: 1,099
Likes: 56
Liked 461 Times in 111 Posts
|
![]()
Try the fuel pressure at 6 psi for starters. Trans oil level is OK? If you use a 2 step change the 2 step module. Had one go bad when we had our Malibu stocker causing same grief.
__________________
68 Chevy11 327 F/S Last edited by Bob Gullett; 05-01-2016 at 01:46 PM. |
![]() |
![]() |
![]() |
#3 |
Senior Member
Join Date: May 2004
Location: Brookfield, CT
Posts: 708
Likes: 13
Liked 319 Times in 68 Posts
|
![]()
Fuel sloshlng over?
__________________
Lee Valentine 1661 STK |
![]() |
![]() |
![]() |
#4 |
Junior Member
Join Date: May 2007
Location: springfield OR
Posts: 70
Likes: 1
Liked 39 Times in 5 Posts
|
![]()
No on the fuel sloshing as it will act similar in park stabbing the gas. Checked the fluid and it is ok. I tried leaving without the two step and had the same results. I will try the fuel pressure on the next run. Thanks for the ideas
__________________
Norm Webber |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: Feb 2008
Location: Georgetown, Indiana (close to Louisville, KY)
Posts: 773
Likes: 530
Liked 228 Times in 105 Posts
|
![]()
Squiters doing as they should? Good flow out of both sides? Rear air flap OK?
|
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Oct 2002
Location: Mahopac, NY
Posts: 666
Likes: 48
Liked 113 Times in 9 Posts
|
![]()
Check the accelerator pump gasket, they dry out from sitting especially after using VP fuels. Chased that for a while once.
__________________
Joe DeMarzo 1317 STK |
![]() |
![]() |
![]() |
#7 |
Member
Join Date: May 2014
Location: E TN
Posts: 463
Likes: 16
Liked 125 Times in 71 Posts
|
![]()
Described hesitation is usually too much or too little fuel. Too much and you'd get a black puff when it finally picked up. Too little and it's just a dead spot. I'd bet too little. I'd start by dissembling carb and cleaning thoroughly.
What carb does it have? |
![]() |
![]() |
![]() |
#8 |
VIP Member
Join Date: Jun 2009
Location: Boulder City, Nevada 89005
Posts: 2,709
Likes: 2,737
Liked 2,399 Times in 679 Posts
|
![]()
X2.............Sound like Carb.
__________________
John Irving 741 Stock 741 Super Stock |
![]() |
![]() |
![]() |
#9 |
Member
Join Date: Aug 2010
Posts: 208
Likes: 13
Liked 63 Times in 24 Posts
|
![]()
how much timing are you using? where is your total set at ?what rpm? just curious
|
![]() |
![]() |
![]() |
#10 |
VIP Member
Join Date: Dec 2001
Location: Texarkana Ark/TX
Posts: 2,446
Likes: 575
Liked 880 Times in 311 Posts
|
![]()
Change the coil wire!
__________________
Adger Smith (Former SS) |
![]() |
![]() |
![]() |
|
|