|
|
06-01-2021, 12:15 AM
|
#1 |
|
Member
Join Date: Jan 2010
Posts: 193
Likes: 87
Liked 114 Times in 34 Posts
|
powerglide build question
Having a powerglide rebuilt for a super stock 327 application. It was previously set up with only 3 friction clutches on the reverse pack. Clearance is .120 thou. Trans. has alum. drum, clutch hub, roller bearings throughout. Last time it was run the brake would not hold the car from moving forward when stalled.
How many frictions are needed to hold with a trans. brake in this application without spinning unnecessary weight? Thinking I may need 5 to make sure it holds. |
|
|
|
06-01-2021, 12:38 AM
|
#2 |
|
VIP Member
Join Date: Dec 2001
Location: Texarkana Ark/TX
Posts: 2,446
Likes: 575
Liked 880 Times in 311 Posts
|
Re: powerglide build question
PM sent
__________________
Adger Smith (Former SS) |
|
|
|
| Liked |
|
06-03-2021, 09:56 AM
|
#3 | |
|
Junior Member
Join Date: Apr 2017
Posts: 93
Likes: 19
Liked 30 Times in 16 Posts
|
Re: powerglide build question
Quote:
It's not slipping, reverse is late to the party. |
|
|
|
|
| Liked |
 |
|
|
Linear Mode
