Mixing bearings for clearance

[Chris "drooze" Wertman]

Originally Posted by Rich Biebel

Another piece of advice........ditch the oil accumulator......I really see no reason for one on a stocker unless your playing with very low oil in the pan or it is doing giant wheelstands..

The very presence of it was at Mopars guidance for "oiling issue" or reduction of it, its going byebye on the next motor, maybe itll go back maybe not....

Were following Duells lead on this hes not running one either I know a few of the hemis ARE after the Tech bulletin and some prior failures (to ours)

I agree, I dont like it and I dont trust this solenoid and its operation. So its going byebye.....

At this point "were on our own" in regards to motors so, well, I dont have to explain why Im not running something they said to run.....easy..

Thanks

I do have a question in a SBC you are running how much rod offset do you have on a wrist pin from the perpindicular center ? This is a left field question but one for "refrence"

Cheers

Chris