generator exhaust

rod · 08-01-2010, 06:51 PM

run the metal bend up into the 2" ABS, several inches. leave the air gap around the bottom. makes a small suction, pulls in fresh air and cools the temp. run the ABS way past the top of the roof.
glue a coupler to one section. the end of the other pipe which will go into the coupler needs to be sanded down so it will remove easily.
you could also fab up an adjustable 'leg' to support the ABS
rod in AZ

08-01-2010, 06:51 PM	#8
rod Member Join Date: Dec 2009 Location: Kingman, NW AZ. in the middle of the longest stretch of Route 66 Posts: 315 Likes: 0 Liked 20 Times in 15 Posts	Re: generator exhaust run the metal bend up into the 2" ABS, several inches. leave the air gap around the bottom. makes a small suction, pulls in fresh air and cools the temp. run the ABS way past the top of the roof. glue a coupler to one section. the end of the other pipe which will go into the coupler needs to be sanded down so it will remove easily. you could also fab up an adjustable 'leg' to support the ABS rod in AZ