Cylinder head milling

FireSale · 12-20-2015, 08:30 PM

There is a formula for this. Read this link and do the measurements and calculations. Each time you shave 1cc out of the chamber it changes it's configuration and you should do the calculations all over again for the next cut.

Since combustion chambers have a different shape depending on the casting family it's hard to make a generalized statement.

http://www.eatonbalancing.com/blog/2...1cc-reduction/
There's a chart that will put in the ballpark at the link.

Dale

12-20-2015, 08:30 PM	#3
FireSale VIP Member Join Date: Feb 2014 Location: Lakewood Washington Posts: 1,407 Likes: 29 Liked 237 Times in 126 Posts	Re: Cylinder head milling There is a formula for this. Read this link and do the measurements and calculations. Each time you shave 1cc out of the chamber it changes it's configuration and you should do the calculations all over again for the next cut. Since combustion chambers have a different shape depending on the casting family it's hard to make a generalized statement. http://www.eatonbalancing.com/blog/2...1cc-reduction/ There's a chart that will put in the ballpark at the link. Dale __________________ Dale Shearon 68 Mustang 6394 Last edited by FireSale; 12-20-2015 at 08:33 PM.